TAURUS 1911 X-MODEL TRITIUM FRONT SIGHTS Tritium Front

TAURUS 1911 X-MODEL TRITIUM FRONT SIGHTS Tritium Front

Here we are offer best quality for TAURUS 1911 X-MODEL TRITIUM FRONT SIGHTS Tritium Front and guarantee cheaper than other online shopping store. Look inside store for get more discount,If you want to see more details Can be ordered at the online store that we recommend

  • IN STOCK
  • UP TO 70% OFF
  • FAST SHIPPING

*** Please check more details at the merchant website.

Recommend Products Hot price.

Glock Trigger Housing Pin
Glock Trigger Housing Pin


Trigger Housing Pin - Polymer - fits Gen4's without the MBS (BOTH) and the Gen3 G36 and G30S Mfg: GlockCheck price and Read more Detail At Glock

Polymer80 P80 Barrels For G17 - G17 Barrel Non-Threaded, Fluted, Stainless Steel, 9mm
Polymer80 P80 Barrels For G17 - G17 Barrel Non-Threaded, Fluted, Stainless Steel, 9mm


Following the company's incredible line of 80-percent Glock pistol lowers, which jump-started an expansive market of handgun builders, an all-new line of Polymer80 G17 barrels are now available, allowing consumers to get this critical component from the same company that offers build-ready frames. Each Polymer80's G17 barrel is made to an incredible level of quality, starting from the sourcing of barrel steel in the form of 17-4 PH stainless-steel bar stock from steel producers right here in the USA. The steel is then machined to precision tolerances, broach-cut rifled and heat-treated to 42 HRC. After that, a range of optional finishes is available for consumers looking for Mfg: Polymer80Check price and Read more Detail At Polymer80

Egw 1911 Guide Rods - One-Piece Sti Tungsten Rod
Egw 1911 Guide Rods - One-Piece Sti Tungsten Rod


5" One Piece Guide Rod: Fits flush with the slide so you can turn the bushing to disassemble the gun. This guide rod also features a takedown hole. This tungsten guide rod should be checked by a gunsmith familiar with the 1911 design. It may require minor fitting to contact the frame evenly. Failure to do so may lead to premature wear and/or breakage which will not be covered under warranty. The head of the guide rod has smooth beveled edges to make for a seamless look. Mfg: Egw SPECS: .326" (8.2mm) diameter. Fits 1911 Auto, or STI, Govt. length slides with 5" (12.7cm) barrels. Tungsten 3.1 oz.(88 g).Check price and Read more Detail At Egw

Little Crow Gunworks Wft 2 Trimmer - 264 Winchester Magnum Trim Chamber
Little Crow Gunworks Wft 2 Trimmer - 264 Winchester Magnum Trim Chamber


The WFT 2 is the next generation of WFT trimmers. The two main improvements are the ability to trim up to 45 caliber and interchange trim chambers. The WFT 2 has a half inch shaft and requires a half inch chuck to drive it. The feature most customers asked for was the ability to interchange trim chambers. Instead of press fitting the trim chambers, like the original WFT, the trim chambers on the WFT 2 are a slight slip fit in bearing with a groove cut for an O-ring which creates a press fit. Changing out trim chambers is accomplished by removing the cutter and pushing out the trim chamber with the knock-out dowel that is provided. Installing the trim chamber is accomplished by setti Mfg: Little Crow Gunworks, Llc.Check price and Read more Detail At Little Crow Gunworks, Llc.

Copyright © 2020 Increase Sale Now RN53. All Rights Reserved