Here we are offer best quality for REMINGTON REMINGTON 870 BREECH BOLT ASSEMBLY 12 GA and guarantee cheaper than other online shopping store. Look inside store for get more discount,If you want to see more details Can be ordered at the online store that we recommend
*** Please check more details at the merchant website.
Designed for tactical operations, these mounts place the rear sling attachment point in front of the operator, so you can quickly shoulder your weapon without getting tangled. Allows single point sling attachment, or use with a front sling mount for two-point sling installation. Loop accepts slings up to 1¼" wide. Rear Mount installs directly behind receiver, in front of buttstock. Precision machined from aluminum billet, then hardcoat anodized matte black. Right hand model for Remington 870, 1100, and 11-87 positions sling on left side of stock. Ambidextrous model for Remington 870, 1100, and 11-87 accepts HK-style clasps and other clip-on sling fasteners. Benelli version fit Mfg: Gg&G, Inc. SPECS: Rem Rear Mount - Aluminum, matte black. ¼" (6.4mm) long, 1-13⁄16" (4.6cm) wide, 1-7⁄8" (4.8cm) high. Fits 870/1100/11-87, Right Hand only. Rem Ambidextrous Rear Mount - Aluminum, matte black. ¼" long, 2¼" (5.7cm) wide, 1-7⁄8&qCheck price and Read more Detail At Gg&G, Inc.
JP's full mass .308 carrier is designed to provide greater reliability in suppressed setups as well as SBRs and rifles without an adjustable gas system. Heavier than a standard DPMS LR-308 carrier, the JPBC-5 allows for the additional cycling delay required for reliable function in such setups. This design incorporates forward assist serrations, making it compatible with both DPMS and Armalite rifles. Each carrier also includes out Enhanced Gas Ring for more reliable function. Requires DPMS-pattern bolt, firing pin and cam pin. Compatible only with DPMS-pattern bolts, firing pin and cam pin. Mfg: J P EnterprisesCheck price and Read more Detail At J P Enterprises
Specially ground, single-flute, solid carbide drills ideally suited for use by the professional gun trade on hard receivers (as the 03A3 and harder). Cuts a clean chip in hardest file steel, giving true hole. Does not "crumble out" the steel; thus, no chatter. 2" long to give quill clearance when using with Forster and other scope/sight mounting jigs. Kept properly cleaned, will not bind or break. Properly fed, won't work-harden hole surface like spade drill does; decreases tap breakage. Drills "all the way through" hardened steels. Note: Common sense must be used. No guarantee against breakage! Use only to crack the skin Mfg: Brownells SPECS: Sizes available: No. 33 (6-40), No. 31 (6-48), No. 29 (8-32), No. 28 (8-40). Speed approximately twice that of high speed steel, feed rate the same or slightly less.Check price and Read more Detail At Brownells
Copyright © 2020 Increase Sale Now RN53. All Rights Reserved