Here we are offer best quality for Merrell Vortex 8 and guarantee cheaper than other online shopping store. Look inside store for get more discount,If you want to see more details Can be ordered at the online store that we recommend
*** Please check more details at the merchant website.
THE PERFECT TIP & BLADE We started with the tip of the blade, the part that has to fit the gun screw properly, and the most important part of a gunsmith's screwdriver. The blade tips are then custom, precision-ground in a crisply radiused, hollow-ground shape to give maximum strength. And, the ideal parallel section is ground at the tip to fit the screw slot properly through the full width and depth of the slot. (This is what keeps you from buggering screws - a blade tip that evenly distributes the turning torque applied at the handle to the full width and depth of the screw slot.) We made the blades short (you're only 2½" from the workpiece) to give Mfg: Brownells SPECS: 2½" (6.3cm) long shanks. 3¾" (9.5cm) long x 1"(2.5cm) dia. handle. Each screwdriver packed in individual plastic tube.Check price and Read more Detail At Brownells
Eliminate excess cylinder endshake on Colt and clones, plus all Ruger single action revolvers with these stainless steel gas ring shims. Installs between frame and the front of the gas ring to eliminate cylinder binding caused by the cylinder face rubbing the rear of the barrel, and helps cure headspace problems that can lead to misfires. Shim thickness of .0045" accommodates most revolvers that have cylinder endshake problems; remove material from the gas ring for "tighter" guns. Developed by master pistolsmith Ron Power as a cost-effective alternative to stretching the gas ring. Whether you're servicing a worn gun or building a custom one, these shims will help Mfg: Power Custom SPECS: Stainless steel. .0045" thick. For guns with base pin diameter no larger than .260" and gas ring no smaller than .380". Fits Gen. 1, 2, 3 Colt SA and clones, and all Ruger SA revolvers.Check price and Read more Detail At Power Custom
Clamp-on steel extension adds a serrated lever to the side of the hammer spur to give your thumb a large, easy-to-find horizontal grasping surface. A must-have if using a low-mounted scope, heavy gloves, or you just want a hammer that's easy to grasp under stress or in wet weather. Hollow design keeps weight to a minimum, so hammer speed and locktime are unaffected. Holds tight on left or right side of hammer with steel Allen head screw. Mfg: Grovtec Us, Inc. SPECS: Steel, blued, matte finish. Extension - 5⁄8" (15.5mm) long x 3⁄8" (9.2mm) diameter. *Including Big Bore and angle-eject (not 94/22). ** Including 39A, 39M, 1894, 1894C, 1895S, 336C, 336T, 375, 444S, Glenfield 30A.Check price and Read more Detail At Grovtec Us, Inc.
Copyright © 2020 Increase Sale Now RN53. All Rights Reserved