Here we are offer best quality for Marlin Takedown Screw Rear Marlin 60 60BL 60C 60CDU 60CP and guarantee cheaper than other online shopping store. Look inside store for get more discount,If you want to see more details Can be ordered at the online store that we recommend
*** Please check more details at the merchant website.
Made by Clymer, a truly dedicated group of gun people, from best quality, M-7 High-Speed Steel. These are precision tools for the professional gunsmith and will give a lifetime of service when properly cared for. Fully guaranteed. Roughers are .010" smaller in diameter than the final size, do not cut the throat area and should be used to save wear on the Finish Reamer when many chambers are to be cut. If only a few chambers will be cut, a Finish Reamer is all you need. Superb quality reamers made to SAAMI specifications. Mfg: Clymer SPECS: RIFLE REAMERS - 6, right-hand cutting, straight flutes. Solid pilot, integral throat. Stocked in Rougher and Finisher. 7/16" round shank with 3/8" square drive. ¼" round shank on .22 RF. ORDERING: Advise: 1) Stock #. 2) Cartridge Caliber and Name.Check price and Read more Detail At Clymer
The tough nylon coating on these rods absolutely won't scratch the delicate rifling of the finest match barrel and won't peel off like many vinyl coatings do. Smooth turning, ball bearing handle. Supplied with Adapter for standard 8-32 male thread brushes and accessories (Except .17 and 20 caliber rods; they are 5-40 female). Plus, an extra-long Dewey Jag that takes a patch either wrapped-around, or over-the-end, and fits directly onto the rod's male thread. 17C and 20C series rods do not include brush adapter. Use of breech or muzzle bore guide recommended. Mfg: Dewey SPECS: Handles are 1-1/8" (2.9cm) dia. x 2-7/8" (7.3cm) long. The number following the dash in the model number represents the rod length in inches, 1"=2.5cm. 17C rods fit .17 caliber 20C rods fit .20 cal-.22RF. 22C rods fit .22-.26 caliber 30C rods fit .27 caliber and upCheck price and Read more Detail At Dewey
Burris solid steel rings not only ensure accuracy, they provide an extra measure of confidence and peace of mind. Machined from a solid block of steel to exacting tolerance, each top and bottom are matched for strength and fit. Designed to handle any rifle and any recoil from rimfires to magnum calibers. Burris offers a wide selection in 1" and 30mm. Mfg: Burris Measurements are from the bottom of the scope tube to the bottom of the ring: 1" Low .130", Med. .255", High .450". 30mm Med .205", High .330"Check price and Read more Detail At Burris
Copyright © 2020 Increase Sale Now RN53. All Rights Reserved