Here we are offer best quality for Front Sights For Ria 1911 and guarantee cheaper than other online shopping store. Look inside store for get more discount,If you want to see more details Can be ordered at the online store that we recommend
*** Please check more details at the merchant website.
Increases stock length to better fit shooters with long arms. Provides a cushioned, recoil absorbing, non-slip surface. Replaces original pad with no permanent alterations. AR-15/M16 model fits A-1 and A-2 trap door buttstocks; adds ¾" length. CAR-15 model fits collapsible stock; adds ¾". M14/M1A adds 7/8". Ruger model fits 10/22, Mini-Thirty, Model 96, does not fit Mini-14 with serial numbers begining at 580 and higher. Mfg: John Masen SPECS: Polyethylene rubber, black. Serrated face.Check price and Read more Detail At John Masen
This Close Quarters Battle (CQB) 3 Point Tactical Sling is designed to fit Remington 870 12ga shotguns that are fitted with Magpul SGA stocks. It allows the user to sling their long gun in a variety of different carry positions and allows for rapid transition from their long gun to pistol. It is fully ambidextrous for right or left handed users. Comfortable 1.25" wide webbing Emergency Release Buckle (ERB) Supplied with a matte finish steel side front sling mount plate and a rear slider that interfaces with the sling loop on the Magpul SGA stock This Special Operations Patrol (SOP) 3 Point Tactical Sling is designed to fit Remington 870 12ga shot Mfg: Specter GearCheck price and Read more Detail At Specter Gear
Compatible with all M-LOK handguards and forends, these rail sections allow you to attach 1913 Picatinny rail-mounted accessories to your weapon. Rail sections are available in either aluminum or polymer. Aluminum sections are machined from Mil-Spec anodized aluminum. Lightweight polymer sections are injection molded from a proprietary reinforced composite for enhanced strength and durability. Both aluminum and polymer rail sections feature beveled ends to eliminate sharp corners and edges, plus reduce snagging. Includes all necessary hardware for attaching rails to M-LOK slots on aluminum or polymer handguards and forends. Mfg: Magpul SPECS: Aluminum or polymer, matte black. 3 Slots 1-1/2" (3.8cm) OAL. 5 Slots 2-3/8" (6cm) OAL. 7 Slots 3-1/8" (7.9cm) OAL. 9 Slots 3-7/8" (9.8cm) OAL.Check price and Read more Detail At Magpul
HRT Series Rings, precisely machined from an alloy steel billet, with tolerances held to .0002", give maximum scope/ring contact. Holds scope securely against recoil. Four-screw cap lets you align the reticle, tighten the left side of the cap, then the right side without the scope rotating. Radiused edges and corners help prevent snagging while providing attractive appearance. Large, clamp-nut lets you torque rings to Weaver-type or Picatinny bases. Mfg: Tps Products, Llc. SPECS: Alloy Steel, black oxide finish to Mil-C-13924 standards. 5/8" (15.8mm) wide. Height measured from top of base to center of ring. 30mm - Low: .925" (23.5mm).Check price and Read more Detail At Tps Products, Llc.
Copyright © 2020 Increase Sale Now RN53. All Rights Reserved