Here we are offer best quality for Fn Mauser 3906 Rifle With 4x Weaver Scope For Sale and guarantee cheaper than other online shopping store. Look inside store for get more discount,If you want to see more details Can be ordered at the online store that we recommend
*** Please check more details at the merchant website.
Highly recommended for both heavy recoiling 1911s and also 1911s with shorter than Gov't Model slides. The Extreme Service firing pin stop is CNC machined out of an oil-quenching tool steel that was chosen for a balance of impact and wear resistance, with a GI hardness is 44-50Rc. The Extreme Service FPS is made .482" wide so it can be fitted to your slide and extractor to prevent extractor "clocking". It has chamfered fitting pads on each side to make your job easier and the FPS fit better into the slide. It has a 3/64" radius machined on the bottom rear corner and a 3 degree angle at the top rear face, both of which act to take away mechanical advantage from the Mfg: Harrison Design & ConsultingCheck price and Read more Detail At Harrison Design & Consulting
High-quality, steel files designed for one purpose only X"X to cut perfectly square screw slots every time. #7, #9, and #11 files cover the most common slot sizes. Smooth-sided to cut only on the edge. Will not widen the slot as it deepens, or damage the screw head. Cleans up marred slots on hard to replace screws or cuts slots in new screws. Use with Needle File Handles. These files are very thin for precise cutting. Sorry, cannot guarantee against bending or breakage. Sold individually or as a set. Mfg: Friedr. Dick Gmbh SPECS: 5¾" (14.6cm) overall length. Shank is 1½" (3.8cm) long. Thickness: #7 - .027" (.69mm), #9 - .035" (.89mm), #11 - .043" (1.1mm). Set includes one each, #7, #9, #11 files.Check price and Read more Detail At Friedr. Dick Gmbh
TSR Series Rings, precisely machined from an aluminum billet, with tolerances held to .0002", give maximum scope/ring contact. Holds scope securely against recoil. Four-screw cap lets you align the reticle, tighten the left side of the cap, then the right side without the scope rotating. Radiused edges and corners help prevent snagging while providing attractive appearance. Large, clamp-nut lets you torque rings to Mil-STD 1913 (Picatinny) bases. Mfg: Tps Products, Llc. SPECS: 7075-T651 Aluminum Alloy, matte black, hard anodized to Mil-A-8625 standards. 5/8" (15.8mm) wide. Height measured from top of base to center of ring. 30mm - High: 1.225" (31.1mm).Check price and Read more Detail At Tps Products, Llc.
Self-contained drop in trigger. Lightweight 6061-T6 CNC Machined aluminum housing. Wire EDM cut, heat treated, Teflon nickel coated hammer to guarantee a lifetime of reliable service. Backed by the Legendary Timney Lifetime No Hassle Warranty and Customer service. Factory tested and preset at 4lbs. (Not adjustable) Mfg: TimneyCheck price and Read more Detail At Timney
Copyright © 2020 Increase Sale Now RN53. All Rights Reserved