Here we are offer best quality for Evolution Gun Works - EGW Mounting - OpticsPlanet Com and guarantee cheaper than other online shopping store. Look inside store for get more discount,If you want to see more details Can be ordered at the online store that we recommend
*** Please check more details at the merchant website.
Aircraft-grade aluminum scope rings feature self-adjusting clamping legs that fit 3⁄8" or European 11mm dovetail mounts found on many bolt-action rimfire rifles. Each leg moves equally as the clamping screws are tightened to keep the scope centered on the rail. Clamping screws also fit into pre-drilled holes to equally spread the legs to easily slip over oversized rails. 200 Series fits 1" scopes and 300 Series fits 30mm scopes. Available as a one-piece cantilever mount with a 2.4" offset, a pair of scope rings, or as a pair of one standard and one offset ring with a 1.3" offset. Ring pairs available as either single, or double top strap. Single-strap rings measure Mfg: Bkl TechnologiesCheck price and Read more Detail At Bkl Technologies
Save time and money by providing repeatable setup, accurate, measurable adjustments and suitability for many guns. The complete fixtures includes an adapter for the specific gun listed. Purchase more adapters separately for other guns; many jigs combined in one fixture! To use, mount hammer or trigger/sear on adapter, set and lock at correct index mark as instructed. Set stoning angle by counting "clicks" specified to raise or lower elevator and stoning guide. Lock guide, place stone on both roller and hammer or trigger/sear, and stone as normal. Easily adjustable to allow variations in stoning angle for exact, desired trigger pull weight. Same tool Ron Power uses in his own s Mfg: Power Custom SPECS: Blued steel. 5 9⁄16" (14.1cm) long x 2 9⁄16" (6.5cm) wide x 3" (7.6cm) high. 3⁄4" (19mm) thick base. 5 3⁄4 lb. (2.6 kg). IncCheck price and Read more Detail At Power Custom
If none of the common methods for removing a frozen screw work, and drilling is in order, these carbide center drills should be used to center and "start" the hole. With the spindle at fairly high speed, bring the center drill down to the screw head and adjust position until centered in the screw. Apply pressure and cut until center hole is deep enough to allow the proper undersized, regular drill bit to start cutting without catching on the screw head slot. Better for drilling broken taps too, for they will cut center holes in even the hardest ones. And, because of the large body mass of the tool relative to the small drill diameter, it is very sturdy and rigid. Mfg: Brownells SPECS: #1, .125 body/.0468 drill; #2, .187 body/.0781 drill; #3, .250 body/.1093 drill; #4, .312 body/.1250 drill.Check price and Read more Detail At Brownells
Carry more ammunition "at the ready": Professional operators who are unwilling to sacrifice quality, performance, and durability, will find Mesa Tactical's polymer shotshell carriers to be an especially attractive and economical alternative to the low-cost consumer grade plastic shell holders offered by competitors. SureShell Polymer Shotshell Carriers are made from durable, impact resistant polymer. This shotshell carrier system, available in a six shell configuration, features shell holders injection molded from glass filled polymer, secured to the receiver by a lightweight aluminum back plate with brass threaded inserts. The SureShell Polymer Carrier also include Mfg: Mesa Tactical Products, Inc. SPECS: Injection molded from glass filled polymer, lightweight aluminum backplate, matte black. For 12 gauge only. All models include mounting hardware, rubber gasket, and installation instructions. Right Hand models only. Remington Sidemount fits models 870/1100/11-87 (may require modification tCheck price and Read more Detail At Mesa Tactical Products, Inc.
Copyright © 2020 Increase Sale Now RN53. All Rights Reserved