Here we are offer best quality for Glock 17 Factory Slide And Glock 19 Tekmat and guarantee cheaper than other online shopping store. Look inside store for get more discount,If you want to see more details Can be ordered at the online store that we recommend
*** Please check more details at the merchant website.
Low-profile forward grip/hand stop takes advantage of natural body mechanics to give the shooter more precise control, faster pointing, and less operator fatigue. The Magpul AFG (Angled Fore Grip) positions the support hand close to the centerline of the bore for maximum recoil control to aid in fast, accurate follow-up shots. Provides a consistent reference point for finding the correct hand position quickly when mounting the weapon under stress. The natural, ergonomic hand position with the palm facing up results in better blood flow than the "clenched fist" stance often used with vertical grips that leads to fatigue and loss of sensation during long periods in the re Mfg: Magpul SPECS: Reinforced molded polymer, Black, Dark Earth, or O.D. Green. Fits Picatinny-type rails. AFG2 - 4¾" (12cm) long, 13⁄8" (3.5cm) wide, extends approximately 2" (5.1cm) below rail. 2.5 oz. (71g) weight.Check price and Read more Detail At Magpul
Eighteen incredibly thin bits to fit the extra-narrow screw slots often encountered in the gun shop. Take great care when using these bits. The blade MUST fill the slot from side-to-side and edge-to-edge or it will most certainly break on a firmly seated screw. Freeze spray, heat, penetrating oil, a few taps, regrinding the bit for an even better fit - all these tricks can help give success. Mfg: Brownells SPECS: 1½" (3.8cm) long bitsCheck price and Read more Detail At Brownells
The Hornady Lock-N-Load OAL Gauge (formerly Stoney Point) is an extremely easy to use tool. It only takes a couple of minutes to find the overall length for a particular bullet. The tool is threaded on one end to accept specially modified cartridge cases. Once threaded onto the tool, a bullet is inserted into the cartridge. The tool is then inserted into the chamber of your rifle. The push rod on the tool is used to push the bullet up against the rifling. The rod is then locked in place and the tool can be removed from the rifle. You then measure across the base of the cartridge and the top of the bullet with your dial calipers (use of a bullet comparator at this time is highly recommende Mfg: Hornady SPECS: Gauge- Machined aluminum, 12" (30cm) long, anodized finish, red. Straight Gauge for bolt and single shot actions. Curved Gauge for auto, pump, and lever actions.Check price and Read more Detail At Hornady
Copyright © 2020 Increase Sale Now RN53. All Rights Reserved