Here we are offer best quality for Brownells 1911 Barrel Alignment Gauge Barrel Align Gauge Set and guarantee cheaper than other online shopping store. Look inside store for get more discount,If you want to see more details Can be ordered at the online store that we recommend
*** Please check more details at the merchant website.
FIRING PIN SPRING, SPORT, BLUE, SS, TWO TONE Mfg: Sig SauerCheck price and Read more Detail At Sig Sauer
For the professional and home gunsmith alike these punches take much of the frustration out of aligning parts and assemblies. And they provide faster and easier disassembly, too. Furnished with a large, easy-to-grasp, handle that gives excellent control for aligning holes and starting pins. Slightly undersized shank provides a close fit that won't bind in the hole. A slight taper, 3⁄4" from the end is especially useful when fitting parts that require repeated assembly and disassembly. Four sizes fit the majority of pins found on the AR-15, 1911 Auto, Remington 870 and Ruger Revolvers. Won't roll off bench. Alignment/Push Punch Set includes one each of the punches liste Mfg: Brownells SPECS: Handle - Plastic. Shank - Unhardened steel drill rod, or 360 alloy brass . 3¼" (8.2cm) long. OAL - 4¾" (12.1cm) long. Alignment/Push Punch Set - Contains (4) brass and (4) steel punches, (1) brass and (1) steel of each diameter: .092" (2.3mm), .120" (3mm)Check price and Read more Detail At Brownells
Set includes: one, 90 facing cutter to square a muzzle after shortening, or repair damage; one, 45 chamfering cutter to break the edges of the rifling for a clean bullet exit or chamfer a revolver cylinder mouth for quick reloads; plus one handle that fits either cutter and one brass bore pilot. Interchangeable pilot keeps cutter properly aligned. Purchase extra pilots to use one cutter for many different calibers. Pilots for other calibers available separately. Mfg: Brownells SPECS: Facing Cutter X"X Hardened steel. 3¼" (8.2cm) long (except .165" cutter, 2-3/8" (6cm) long). 1" (2.5cm) or .750" (19mm) diameter as required. Chamfer Cutter X"X Hardened steel. 3¼" (8.25cm) long (except .165" cutter, 2-3/8" (6cm) long). ½" (12.7mm) or 5/8" (15.8mm) dCheck price and Read more Detail At Brownells
Eighteen incredibly thin bits to fit the extra-narrow screw slots often encountered in the gun shop. Take great care when using these bits. The blade MUST fill the slot from side-to-side and edge-to-edge or it will most certainly break on a firmly seated screw. Freeze spray, heat, penetrating oil, a few taps, regrinding the bit for an even better fit - all these tricks can help give success. Mfg: Brownells SPECS: 1½" (3.8cm) long bitsCheck price and Read more Detail At Brownells
Copyright © 2020 Increase Sale Now RN53. All Rights Reserved