Here we are offer best quality for Bolt Action Airsoft Sniper Rifle 400 Fps and guarantee cheaper than other online shopping store. Look inside store for get more discount,If you want to see more details Can be ordered at the online store that we recommend
*** Please check more details at the merchant website.
The Rhodesian Sling is a 2 point rifle sling that acts as a shooting support as well as a carry strap. A large forward loop is easily adjusted to accommodate most any shooter and rifle. (Made extra long to fit everyone just trim off any excess). Made in North Carolina with genuine bridle leather solid brass (or Stainless Steel) hardware available in 3 colours: black, walnut brown, or chestnut. Three different hardware choices are offered: solid brass, black, or stainless steel. Choose from either 1" or 1.25" widths and with/without Grovtec Swivels pre-installed. Mfg: Andys LeatherCheck price and Read more Detail At Andys Leather
BERETTA A400 LIT COMPACT 20 GAUGE SYNTHETIC FOREND Mfg: Beretta UsaCheck price and Read more Detail At Beretta Usa
A Large number of Colt-made AR-15s on the market that were produced between 1991 and 2009 are what's called a "large-pin lower," which means that they accept receiver pins with a diameter of 0.172-inch. For owners of guns with these receivers, getting parts that fit can be a challenge, but CMC Triggers stepped up with its AR-15 Single-Stage Large-Pin Triggers. The CMC AR-15 Single-Stage Large-Pin Triggers can be had with either a curved or flat trigger bow and are available in trigger-pull weights of 4.5, 5.5 and 6.5 pounds. Like CMC's other designs, these trigger units drop into any Colt large-pin lower receiver without any modifications. The triggers will not drop Mfg: Cmc TriggersCheck price and Read more Detail At Cmc Triggers
O-1 OIL HARDENING DRILL ROD ROUND Carbon - .95% Manganese - 1.20% Silicon - .25% For ¼" round and larger, we carry oil hardening drill rod rather than water hardening. The O-1 in this size range is characterized by good machineability, smooth finish as well as superior dimensional stability and excellent hardening characteristics. We recommend it for use in dies, tools, parts, and punches. Excellent for general use in the shop. HARDENING: Heat slowly to 1475° F. - 1525° F. If a controlled furnace is not available, use 1500° Tempilaq. Hold at this temperature for a few seconds then quench in a light quenching oil. TEMPERI Mfg: Brownells SPECS: Rods are 18" in length.Check price and Read more Detail At Brownells
Copyright © 2020 Increase Sale Now RN53. All Rights Reserved