Here we are offer best quality for Air Gun Rifles Canada and guarantee cheaper than other online shopping store. Look inside store for get more discount,If you want to see more details Can be ordered at the online store that we recommend
*** Please check more details at the merchant website.
Hand cut and taper-ground to make "factory perfect" impressions when marking custom rifle barrels and other metal objects you want to professionally identify. Made from only the finest quality steel, selected for its proven ability to stand the gaff, then heat-treated to three distinct hardnesses. The character end is hardened to Rc 62 to prevent chipping. Hammer end is crowned and hardened to prevent mushrooming and the center is hardened to transmit the hammer blow.Sharply cut Gothic characters ensure a deep, clear impression. Smooth, ground taper improves appearance and eliminates cracks that sometimes develop in a rough taper. Each stamp is individually inspected and marked Mfg: Young Brothers Stamp Works Inc SPECS: Steel Stamps stocked in 1/16" (1.6mm) and 3/32" (2.4mm) sizes. The characters are cut into the end of a steel bar measuring ¼" (6.4mm) square x 2-3/8" (6.0cm) long. Purchase as sets or by the individual piece.Check price and Read more Detail At Young Brothers Stamp Works Inc
Made by Clymer, a truly dedicated group of gun people, from best quality, M-7 High-Speed Steel. These are precision tools for the professional gunsmith and will give a lifetime of service when properly cared for. Fully guaranteed. Roughers are .010" smaller in diameter than the final size, do not cut the throat area and should be used to save wear on the Finish Reamer when many chambers are to be cut. If only a few chambers will be cut, a Finish Reamer is all you need. Mfg: Clymer SPECS: THROATERS - 5, left-hand, spiral flutes. .002" larger than bullet diameter. 2 throat angle. Used to lengthen throat to increase freebore. " diameter round shank. ORDERING: Advise: 1) Stock #. 2) Cartridge Caliber and Name.Check price and Read more Detail At Clymer
The Hunter X-22 Takedown Forend is intended for use with additional barrels on rifles currently equipped with the Hunter X-22 Takedown Stock. Made from high quality reinforced polymer, the X-22 Takedown Forend features a reversible barrel tray, ensuring proper fit for factory pencil profiles as well as heavy bull barrels with up to 0.920" outer diameter. It features multiple M-LOK slots for accessory attachment and an adjustable barrel-tensioning shim in the forend for setting barrel preload (the barrel may also be free-floated). It also includes a dimpled drill point at the bottom of the forend for installation of sling swivel studs for bipod or sling swivel use. FEATURES Mfg: MagpulCheck price and Read more Detail At Magpul
Sinclair Bump Gage Inserts are used to measure the amount of shoulder bump when setting up full length sizing dies. Our Bump Gages install in either of our comparator bodies and are machined to fit particular shoulder angles of cartridges. Rather than measuring to the datum line, these gages indicate off of the shoulder of the case to get a better, more easily assessable measurement of how much you are actually sizing your cases. We usually recommend between .001" to .002" bump for bolt action rifles and between .003" and .005" for AR-15 type rifles. Also a useful tool for keeping your brass and loaded ammunition separated if you have multiple rifles chambered for the Mfg: Sinclair InternationalCheck price and Read more Detail At Sinclair International
Copyright © 2020 Increase Sale Now RN53. All Rights Reserved