Here we are offer best quality for Agency Optic System Plates Aos Plate For Rmr Front Dovetail and guarantee cheaper than other online shopping store. Look inside store for get more discount,If you want to see more details Can be ordered at the online store that we recommend
*** Please check more details at the merchant website.
Graceful design sets low, allowing lowest possible scope mounting. One-piece construction, beautiful, non- glare, blued finish. Right-hand operation only. Easily installed, requiring slotting of bolt sleeve. Mfg: Dayton Traister SPECS: " (19mm) long arm, 3/16" (4.8mm) wide. Blued steel.Check price and Read more Detail At Dayton Traister
Badger Ordnance's DMR 30mm Scope Rings were specifically designed for the USMC Designated Marksman Rifle and are optimized for use on the M14/M1A platform. They will work on any rifle with a MIL-STD 1913 Picatinny scope rail - an enough clearance for the scope's objective bell. Badger Ordnance DMR 30mm Scope Rings are machined from steel barstock as serialized, matched pairs, so they are truly as close to identical as technologically possible - unlike mass-produced rings. The benefit of matched rings is far lower risk of damage to your scope caused by misaligned rings. Sold in matched pairs Robust hex-head clamping nuts Torx-head ring cap screws Mfg: Badger OrdnanceCheck price and Read more Detail At Badger Ordnance
Set of six, stress-proof, hardened chrome-moly steel barrel links helps correct most barrel-to-frame fit and feeding problems on 1911 autos. Includes the following link sizes (measured center-to-center from barrel link pin hole to slide stop hole): factory standard #3 (.278"), as well as #0 (-.015"), #1 (-.010"), #2 (-.005"), #4 (+.005"), and #5 (+.010"). #0 is for Accurail-equipped guns with rails that have been moved down. #1-#5 also available separately. Mfg: Egw SPECS: 4140 chrome-moly steel, heat treated to Rc 39-44, blued.Check price and Read more Detail At Egw
Same performance in a short, compact brake that looks "right" and saves weight on carbines or lighter rifles. .750" (19mm) O.D. can be turned down to .650" (16mm) to match thinner barrel contours. Mfg: Vais SPECS: Stressproof steel (CM), in the white, 416 stainless steel (SS), heat treated. 1¾" (4.4cm) ;long. ½"-32 tpi. Requires threading of barrel.Check price and Read more Detail At Vais
Copyright © 2020 Increase Sale Now RN53. All Rights Reserved