Here we are offer best quality for Aero Gen 2 Lower and guarantee cheaper than other online shopping store. Look inside store for get more discount,If you want to see more details Can be ordered at the online store that we recommend
*** Please check more details at the merchant website.
Our neck turning tool mandrels are made from high grade stainless steel on Precision turning centers. The shape, finish, and size are the result of years of use and experimentation by many hand loaders. All of our mandrels fit both our NT-3000 and NT-1000 neck turning tools and most of our older model neck turning tools. Our neck turning tool mandrels measure approximately about .002"" less than the bullet diameter for the caliber. Our expander mandrels are made .001"" larger than the turning mandrels. Using an expander mandrel prior to neck turning sizes the case to fit the neck turning mandrels perfectly. This correct fit makes the turning process more precise and much easier. Any of the m Mfg: Sinclair InternationalCheck price and Read more Detail At Sinclair International
Adding advantages for shooters on the range and hunters in the field is the primary purpose of all the heightened features seen on the new Leupold VX-5HD 1-5x24mm Scope. The Leupold VX-5HD 1-5x24mm Scope is built to provide enhanced capabilities in low light, thanks to the company's Twilight Max light-management system, and optical clarity is improved with high-definition glass. Features Illuminated Firedot 4 Fine Reticle located in the second focal plane Powered by CR2032 battery Adjustment value: 1/4 MOA Weight: 13.09 ounces An additional benefit of the new scope can be found in the pop-up adjustment turrets for easy zeroing and dialing. Mfg: LeupoldCheck price and Read more Detail At Leupold
Made by Clymer, a truly dedicated group of gun people, from best quality, M-7 High-Speed Steel. These are precision tools for the professional gunsmith and will give a lifetime of service when properly cared for. Fully guaranteed. Roughers are .010" smaller in diameter than the final size, do not cut the throat area and should be used to save wear on the Finish Reamer when many chambers are to be cut. If only a few chambers will be cut, a Finish Reamer is all you need. Superb quality reamers made to SAAMI specifications. Mfg: Clymer SPECS: RIFLE REAMERS - 6, right-hand cutting, straight flutes. Solid pilot, integral throat. Stocked in Rougher and Finisher. 7/16" round shank with 3/8" square drive. ¼" round shank on .22 RF. ORDERING: Advise: 1) Stock #. 2) Cartridge Caliber and Name.Check price and Read more Detail At Clymer
With the increasing use of roll pins in guns, we've been looking for a good assortment of them in stainless steel to offer. Finally found it - with 850 pins in 8 diameters and various lengths (see below). Should take care of most gun needs!Great for other shop jobs too. Make jigs, fixtures, or use to replace taper pins, dowels, groove pins, set screws, etc. Will not slip or vibrate out. Easy to use, as require no threading or taping. Can be cut to any length. Use the Roll Pin Punches for positive, safe removal. Mfg: Brownells SPECS: Kit (and Refill Paks) includes: 192 total 1/16" (1.6mm) diameter pins; 180 total 5/64" (2mm) diameter pins; 144 total 3/32" (2.4mm) diameter pins; 96 total 1/8" (3.2mm) diameter pins; 144 total 5/32" (2mm) diameter pins; 36 total 3/16" (4.8mm)diameter pins; 36 total 7/32" (5.6mm) diaCheck price and Read more Detail At Brownells
Copyright © 2020 Increase Sale Now RN53. All Rights Reserved