Here we are offer best quality for Beautiful King Size Beds and guarantee cheaper than other online shopping store. Look inside store for get more discount,If you want to see more details Can be ordered at the online store that we recommend
*** Please check more details at the merchant website.
O-1 OIL HARDENING DRILL ROD ROUND Carbon - .95% Manganese - 1.20% Silicon - .25% For ¼" round and larger, we carry oil hardening drill rod rather than water hardening. The O-1 in this size range is characterized by good machineability, smooth finish as well as superior dimensional stability and excellent hardening characteristics. We recommend it for use in dies, tools, parts, and punches. Excellent for general use in the shop. HARDENING: Heat slowly to 1475° F. - 1525° F. If a controlled furnace is not available, use 1500° Tempilaq. Hold at this temperature for a few seconds then quench in a light quenching oil. TEMPERI Mfg: Brownells SPECS: Rods are 18" in length.Check price and Read more Detail At Brownells
Our neck turning tool mandrels are made from high grade stainless steel on Precision turning centers. The shape, finish, and size are the result of years of use and experimentation by many hand loaders. All of our mandrels fit both our NT-3000 and NT-1000 neck turning tools and most of our older model neck turning tools. Our neck turning tool mandrels measure approximately about .002"" less than the bullet diameter for the caliber. Our expander mandrels are made .001"" larger than the turning mandrels. Using an expander mandrel prior to neck turning sizes the case to fit the neck turning mandrels perfectly. This correct fit makes the turning process more precise and much easier. Any of the m Mfg: Sinclair InternationalCheck price and Read more Detail At Sinclair International
The MAX-50 rings are on inch wide, giving them 60% more holding power than any other ring available from Badger Ordnance. Utilizing 6 #8-40 Torx screws to distribute the load providing the maximum amount of holding power while minimizing the chance of damaging the scope. Machined from Steel or Aluminum as serialized matched pairs. MIL STD 1913 compatable, designed for the demanding .50 BMG round. Mfg: Badger OrdnanceCheck price and Read more Detail At Badger Ordnance
Set includes: one, 90 facing cutter to square a muzzle after shortening, or repair damage; one, 45 chamfering cutter to break the edges of the rifling for a clean bullet exit or chamfer a revolver cylinder mouth for quick reloads; plus one handle that fits either cutter and one steel bore pilot. Interchangeable pilot keeps cutter properly aligned. Purchase extra pilots to use one cutter for many different calibers. Pilots for other calibers available separately. Mfg: Brownells SPECS: Facing Cutter X"X Hardened steel. 3¼" (8.2cm) long (except .165" cutter, 2-3/8" (6cm) long). 1" (2.5cm) or .750" (19mm) diameter as required. Chamfer Cutter X"X Hardened steel. 3¼" (8.25cm) long (except .165" cutter, 2-3/8" (6cm) long). ½" (12.7mm) or 5/8" (15.8mCheck price and Read more Detail At Brownells
Copyright © 2020 Increase Sale Now RN53. All Rights Reserved